Quickie Pulse Manual de servicio descargar pdf (Pagina 32)

PULSE 6 SERVICE MANUAL

PAGE 4.3

2009SUNRISE MEDICAL

Section 4

12. If the above tests pass, replace the wiring

harness leading from the batteries through the

circuit breaker and control module. Retest as

necessary.

10. If battery voltage is not present, use a

Multimeter and measure for continuity across the

fusible links connected to positive (+) terminal of

each battery (ﬁ g. 4.7). Normal resistance is less

than 1 ohm. If open, replace the defective battery

harness. Retest as necessary.

Caution: To prevent damage to the Multimeter,

ensure that the batteries are disconnected.

11. Check for continuity across the circuit

breaker (ﬁ g. 4.8). Normal resistance is less

than 1 ohm. If open, replace the circuit breaker.

Retest as necessary. Note: Access to the circuit

breaker terminals is easier if the front battery is

removed.

Rnet Troubleshooting Procedures

9. Verify that battery voltage is present at

each connector leading to the batteries (ﬁ g. 4.6).

fig. 4.6

fig. 4.7

fig. 4.8

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 61 62

Sin comentarios

Quickie Pulse Manual de servicio Pagina 32