Quickie Pulse Manual de servicio descargar pdf (Pagina 22)

PULSE 6 SERVICE MANUAL

PAGE 1.1

2009SUNRISE MEDICAL

Section 1

Battery Connection Test

1. Check that the female VR2 Bus plug on

the chair has voltage. Set the meter to DC volts

and measure pins 4 (using the red lead of the

meter) and 1 (using the black lead of the meter)

as shown in (fig A1.5.1)

A1.5.1

A1.5.2

2. If the voltage meter reads full voltage, then

replace the joystick module

If the voltage meter reads zero voltage measure

the corresponding pins on the VR2 controller as

shown in (figure 1.5.2).

If the voltage meter reads full voltage, then replace

the jumper cable. If the voltage meter reads zero,

then measure the Battery Connector as shown in

(fig 1.5.3).If the voltage meter reads full voltage,

then replace the controller, or else proceed to the

next step.

Troubleshooting: No Power (cont.)

A1.5.3

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 61 62

Sin comentarios

Quickie Pulse Manual de servicio Pagina 22